Kicker 2004 SS Components Manuel du propriétaire télécharger pdf (Page 12)

12

SS Component Systems

Installation

Tweeter Mounting

Your tweeter can be flush mounted into

your panel with or without the 15° angle

rings.

Cut a 1-15/16” (4.9 cm) hole in

your panel for the tweeter. Be

sure there is clearance behind

the panel for the tweeter and

wiring.

WITHOUT ANGLE RINGS

Place the tweeter into

the panel and secure

by tightening (clock-

wise) the Tweeter

Mounting Nut.

This is what you should

end up with after securing

the Tweeter to the panel

using the Mounting Nut.

If necessary, the legs of the Tweeter

Mounting Nut can be cut to fit

thicker panels. Trim each leg at

the score line. Remove only 1

section from each leg at a time

until desired length is achieved.

WITH ANGLE RINGS

Place the

tweeter through the

Front Angle Ring

and then into the

panel.

Next place the

Back Angle Ring over the Tweeter and line

up the narrow part of the Back Angle Ring

with the wide part of the Front Angle Ring

for proper operation.

Attach the Tweeter

Mounting Nut (clockwise)

but do not tighten

completely.

Rotate all the parts in

unison until the tweeter is

angled in the desired

direction.

Secure the assembly by tightening

(clockwise) the Tweeter Mounting Nut.

This is what you should

end up with after securing

the Tweeter to the panel

using the Mounting Nut.

1-15/16" (4.9 cm) Hole

Panel

Panel

Tweeter

Mounting

Nut

Tweeter

Wire

Panel

Tweeter

Mounting

Nut

Tweeter

Wire

Trim Here

Panel

Tweeter

Mounting

Nut

Tweeter

Wire

Front

Angle

Ring

Back

Angle

Ring

Panel

Tweeter

Mounting

Nut

Tweeter

Wire

Front

Angle

Ring

Back

Angle

Ring

Panel

Tweeter

Mounting

Nut

Tweeter

Wire

Front

Angle

Ring

Back

Angle

Ring

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Commentaires sur ces manuels

Pas de commentaire