Kicker 2013 KX Stereo Amplifier Manuel du propriétaire télécharger pdf (Page 5)

OPERATION

Automatic Turn-On Selection: The KX series offers three different automatic turn-on modes that can be

selected on the end panel; +12V, DC Offset, and Audio. Using either the DC Offset or Audio mode causes the

REM terminal to have +12V out for turning on additional ampliﬁ ers.

• Remote Turn-On: Set the switch to +12V to use the remote turn-on lead from your source unit. Run 18

gauge wire from the Remote Turn-On Lead on your source unit to the terminal labeled REM between the

ampliﬁ er’s positive and negative power terminals. This is the preferred automatic turn-on method.

• DC Offset Turn-On: If Remote Turn-On is not an option, the next best setting is DC Offset. The DC Offset

mode detects a 6V DC offset from the HI-Level speaker outputs when the source unit has been turned on.

• Signal Sense Turn-On: The Audio setting is the ﬁ nal alternative for Automatic turn-on. This is a Signal Sense

turn-on method that detects the incoming audio signal from your source unit and automatically turns on the

amp. This turn-on method will not work properly if the input gain control is not set appropriately.

Input Level: The RCA inputs on KICKER KX ampliﬁ ers are capable of receiving either Hi or Low-level signals

from your source unit. If the only output available from your source unit is a Hi-Level signal, simply press in the

Input Level switch on the ampliﬁ er. Refer to the wiring section of this manual for additional instructions.

Input Gain Control: The input gain control is not a volume control. It matches the output of the source unit to

the input level of the ampliﬁ er. Turn the source unit up to about 3/4 volume (if the source unit goes to 30, turn it

to 25). Next, slowly turn (clockwise) the gain on the ampliﬁ er up until you can hear audible distortion, then turn it

down a little.

Crossover Control with Frequency Multiplier Switch: The variable crossover on the side of the ampliﬁ er

allows you to set the crossover to OFF, HI-PASS, LO-PASS or BAND-PASS at frequencies from 10Hz–5,000Hz.

The setting for this control is subjective.

KICK EQ Bass Boost Control: The variable bass boost control on the side of the KX200.2 ampliﬁ er is

designed to give you increased output, 0–18dB, at 40Hz. The setting for this control is subjective. If you turn it

up, you must readjust the input gain control to avoid clipping the ampliﬁ er.

Mini-USB for internal use only; do NOT remove or tamper. KICKER is not responsible for any

damage to equipment resulting from connections made to this port.

2013 KX Stereo Amp Rev C.indd 52013 KX Stereo Amp Rev C.indd 5 10/24/2012 4:54:30 PM10/24/2012 4:54:30 PM

1 2 3 4 5 6 7 8 9 10 ... 27 28

Pas de commentaire

Kicker 2013 KX Stereo Amplifier Manuel du propriétaire Page 5